Gutter reattachment
Loose gutters are refastened and pitched toward downspouts at the right slope.
Exterior Services
Fascia Repair Whippany, NJ
A roofing contractor in Whippany can fix soft, split or loose fascia along the roof edge, whether it is painted wood, PVC or wrapped in aluminum, and check the rafter tails behind the board while it is off. One call to (862) 693-4362 reaches a nearby roofer who handles fascia repair.
When a fascia board goes soft, the cause is almost always water running down the back of the gutter instead of into it. A missing or short drip edge lets rain curl under the shingles and run down the face of the board, while clogged gutters overflow over the back edge and soak it. The wood slowly loses strength until the gutter spikes or hanger screws no longer hold.
Fascia damage does not stay in the fascia for long. Behind the board are the rafter tails, the roof decking at the edge and the soffit, and water that gets past the fascia soaks into all of them. Aluminum wrap over wood can hide all of this, since the metal looks fine while the board behind it crumbles.
It helps to know what you are seeing before you call. Note where paint is peeling, where gutters sag or have pulled away, and whether water pours over the gutter in heavy rain. Say whether the fascia is bare wood, painted, PVC or wrapped in metal, since that changes the repair.
Depending on what the roofer finds, fascia repair in Whippany, NJ can go hand in hand with soffit repair and gutter installation.
Dealing with this in Whippany, NJ right now? Call (862) 693-4362 to reach a nearby roofing contractor.
Call nowThe process
How fascia repair works
Here is how a roofer typically handles a fascia repair.
Inspect the roof edge
The roofer checks the drip edge, the first course of shingles, the gutter pitch and the downspouts above the damaged fascia. An awl or screwdriver finds the edges of the soft wood.
Take down the gutter
To reach the fascia, the gutter over it is removed and the hangers pulled. Old spikes and loose hangers are not reused.
Repair the framing
The roofer looks at the rafter ends and the sub-fascia, since soft framing will not hold a new board. Skipping it is the most common reason fascia fails twice.
Fit the board
A replacement board matched to the existing size goes up, sealed at the ends and joints. PVC and composite boards do not rot and hold paint well.
Reset the drip edge
Drip edge flashing is slid under the shingles and over the gutter back, so water cannot reach the wood. It is a small part that does most of the work.
Reattach gutters
Gutters are rehung on the new fascia with a slight slope toward the outlets. The board is painted to match if it is wood.
What is included
Fascia repairs a roofer can handle
Fascia wrapping
Coil stock wrap is bent to fit over solid boards with the drip edge lapped over it.
Framing repair
Soft framing at the roof edge is reinforced to keep the roof edge straight.
Drip edge installation
New drip edge is tucked under the shingles over the gutter to keep runoff off the fascia.
Rotted board repair
Rotted sections of fascia are cut out and replaced with new boards with sealed joints and ends.
Related service
Fascia Board Replacement Whippany, NJ
Fascia board replacement means taking off whole lengths of board rather than patching short sections. With the old fascia off, every rafter end can be checked and repaired before the new boards are fastened. It is also the moment to choose a material, whether primed wood, PVC, composite or wood with an aluminum wrap.
For many Whippany homes it makes sense to replace fascia while the gutters are off for replacement anyway. Ask whether the roofer plans to remove the old boards or wrap over them, because wrapping soft wood only hides the rot. Also ask about the size of the new boards, since fascia that is too narrow can leave gaps at the soffit and gutter.
Related service
Fascia Board Repair Whippany, NJ
Fascia board repair handles damage that is limited to a few spots, such as a rotted corner, the area under a leaky gutter seam or a section by a downspout. Angled joints hold paint and shed water better than straight cuts, so they are the standard for patch repairs. Very small areas of surface rot can sometimes be treated with a wood consolidant and exterior filler, then primed and painted.
Patching a fascia board in Whippany without fixing the gutter or drip edge above it just buys a season or two. The cause is often a leaking gutter corner or a downspout that backs up. Done right, the repair is hard to spot once painted.
Local help
Fascia Repair Near Me
In Whippany, fascia tends to fail first on the sides of the house where gutters clog fastest. From Whippany out to neighboring towns such as Cedar Knolls, Parsippany, Morris Plains and Florham Park, older roof edges often need board and rafter tail repair while newer ones more often need drip edge and gutter fixes, and replacing a short section early is far easier than rebuilding the roof edge later.
Need fascia repair around Whippany? Call (862) 693-4362 for a Whippany roofer who serves the towns around it too.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Whippany, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Drier ceilings
Small roof problems caught early usually stay small repairs.
Local knowledge
Roofers in Whippany know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Common questions about fascia repair
Do I need new fascia boards or just a repair?
Short sections of rot can be repaired by cutting out the bad wood and scarfing in a new piece. Long stretches of soft wood are better handled by replacing the whole board. Either way, the rafter tails behind the board need to be checked.
Do fascia boards affect my gutters?
The fascia is what gutters are fastened to. Soft fascia lets the fasteners work loose, which is often the first sign of rot. New fascia and new hangers together restore a solid gutter line.
What causes fascia boards to rot?
Water getting behind the gutter is the main cause. A missing drip edge, clogged gutters and leaking gutter seams all keep the wood wet after every rain. Once the paint fails, the wood takes on water quickly.
What is the best material for fascia?
Primed wood, PVC, composite and aluminum-wrapped wood are the usual choices. Wood looks traditional and is easy to work with, though it needs upkeep. The drip edge and gutters decide how long any fascia lasts.
Is it safe to wrap rotted fascia in aluminum?
Covering rotted wood with aluminum hides the rot instead of stopping it. Since gutters hang from the wood, the problem shows up later as a falling gutter. Wrap is a good finish over new or solid fascia.
More questions? Call (862) 693-4362
Other services that may help
Soffit Repair
Repairs for rotted, sagging or loose soffit panels under the roof eaves, before rot spreads into the fascia and rafter tails.
Learn moreGutter Installation
Gutter installation that carries roof water away from the siding, fascia and foundation, from K-style aluminum to half-round and copper.
Learn moreGutter Repair
Gutter repair for leaking seams, sagging runs, loose hangers and broken downspouts, before the leaks rot the fascia behind them.
Learn moreRoof Repair
Repairs for missing shingles, lifted tabs, cracked pipe boots, loose flashing and soft decking, without replacing a roof that still has life left.
Learn more
Looking for something else?
See all roofing servicesTalk to a Whippany roofer about fascia repair
Call (862) 693-4362 to talk to a roofer serving Whippany, NJ.